copper wire wound around 26 iron laminations, because the coil is fitted in the frame without the need for any mounting holes through the coil it is our most powerfull coil yet!
The Evolution incorporates an alloy base plate attached to the machine with 4 small screws, this is also designed to act as a heat sink for the coil and draws any heat generated in the coil safely away from the coil and to the sides of the machine where it dissipates rapidly. Under normal operating conditions the machine seldom becomes more then warm. Most wiring and connectoes are no covered, twin capacitors are housed under the base plate out of sight.
Spring tension is pre-set with just the right angle on the back post so no need to ne bending springs. The armature bar houses our new noise and vibration dampening rubber which is simple to fit and requires no glue.Fully adjustable as a liner or a shader. The Pro-Matic Evolution machine will slot into any D. C. setup and quickly become your favorite machine! Weighs 12.45 ounces.
The Pro-Matic Generation 2 Evolution Machine complete as pictured with 20 Mill stainless steel Grip, Tube and Tip.
CAT.#150SS
NZ$495.00
Other Tube arangements available:
The Pro-Matic Generation 2 Evolution Machine with 20 mill. stainless steel Grip, Tube and plastic Disposa-Tip.
CAT.#150SP
NZ$475.00
The Pro-Matic Generation 2 Evolution machine, Head only.
CAT.#150H
NZ$440.00

The Generation 2 Pro-Matic Classic D. C. Tattoo machine.

The Pro-Matic Gen.2 Classic machine. Classic look but all the punch and reliability of the Pro-Matic system. The Pro-Matic Classic now features the same vibration and noise dampening system as the new Evolution machine. The damper now pulls through the Armature bar. No holes in the top of the coil means more power and less heat build-up. No more glue required. Weighs 8.2 ounces.